Cart: 0 item(s) - £0.00
For detailed information about any product visit the Product index.

BV4613: Serial & I2C 192x64 LCD Graphic Display Controller

Product Condition:   New
Quantity
£12.00
Send to a friend

LCD 192x64 Serial & I2C Graphic Display Controller (BV4613)

top anotated image

The BV4613 is a 192x64 serial graphic display controller designed for displays that use three KS0108B controllers. It provides a universal serial interface that can easily be controlled by escape commands. It has full scrolling capability and 3 fonts. The serial interface can be either a standard asynchronous OR I2C, this is fully selectable by the user. This datasheet describes the controller and thus the display capabilities, the controller is normally supplied attached to a display, however the controller can be supplied separately.

online icon Data sheet and resources

Please make sure that your display is compatible with this controller before purchase.

This device will work with Serial AND I2C

Back of display

This shows how the device fits onto the back of the display. Any information (text) presented to the interface is replicated on the display and there is a choice of fonts, all selectable via escape codes. Example of the controller connected to the display and what it will display when connected.

Dsiplay showing fonts

When the text reaches the bottom of the screen it will begin scrolling. In addition to this it is capable of displaying graphics and there are commands that will enable the drawing of lines, rectangles and circles.

Dsiplay showing graphics

There are many other features to this display controller including the ability to set up a macro so that it will run at start up and display your own sign-on screen.

NOTE: This item if for the controller ONLY, the display is NOT included.In case you are wondering, it is the controller that gives the display the ability to draw lines and display fonts.

Connector details

Pin

Function

Function

Pin

2

nDD

RX

1

4

Reset

TX

3

6

SCL

+V

5

8

SDA

7

10

nRTS

Gnd

9

This is the 10 way connector at the back of the display, it requires a 5V power supply connected to pins 5 & 9 and can be used as a normal serial device using the TX & RX pins. If I2C is required than connect an I2C bus to the SCL and SDA lines and the display will revert to I2C mode at switch on.

Write an online review and share your thoughts with other shoppers!

Be the first to review this product