Cart: 0 item(s) - £0.00
For detailed information about any product visit the Product index.

BV4243G: I2C Keypad Front Panel with 16x2 LCD, Green

Product Condition:   New
£12.50
Send to a friend

I2C Microcontroller User Interface - Front Panel

This is an LCD front panel fitted with a 16 x 2 display (Green Backlight) it also has a 16 way touch pad, keypad.  Both the display and touch pad can be controlled via an I2C interface. In addition it has a beeper output so it is a complete user interface. Arduino and Raspberry Pi libraries available, see downloads link below. (NOTE beeper not fitted)

top anotated image

Fitted with a standard low cost blue display.

top anotated image
This is the back view.

Connections:

Pin

Description

SCL

I2C clock

GND

Ground

SDA

I2C data

V+

2.5V to 5V [1]

Pin

Description

RST (in)

Reset;  leave disconnected, pull low to reset the device.

INT (out)

Normally high, will go low if there are any keys in the buffer.

KEY (out)

Goes low only when a key is being touched otherwise it is high

BELL (out)

Momentarily goes high when a key is touched, this can be attached to a buzzer to get audio feedback

Only 2 I2C wires are required to control the device leaving all the other microcontroller pins free.

online icon Data sheet and resources

Description

Each touch pad consist of two capacitive touch channels and a key is determined as being pressed when both channels are activated. All of this is decoded internally so the host is presented with a simple key value.

For ease of use the keypad will buffer keys so they can be read at a later time by the host microcontroller.

The front of the PCB is designed so that a vinyl, glossy photo paper or similar similar overlay can be stuck to it thus the pads can be designed for the application in mind. Several pads can be grouped to make one larger pad if required.

top anotated image

** This example is fitted with an RGB display, the item for sale is fitted with a green display.

The device will also exactly fit into the E75 project box supplied by m-r-s

BV4242 Features

  • I2C Control
  • User selectable I2C address
  • Software variable back light
  • Three PWM back light outputs
  • 16 Pad touch keypad
  • 32 key buffer
  • Interrupt pin
  • Beeper output
  • Pads fully configurable
  • Mounts is standard box
  • User printable Front panel overlays
  • Wide voltage 2.5V to 5V *
  • 10.4mA @ 5V
  • 3.7mA @ 5V sleep mode
  • Only 2 wires for full I/O control

* This will largely depend on the back light that is fitted.

NOTE: Comes without the beeper and front overlay but there are templates on line to print using an ink jet printer

Write an online review and share your thoughts with other shoppers!

Be the first to review this product